|
The b125 can be used in small rooms and showcases requiring gentle humidification. It is not recommended to use humidifiers in showcases without a control system.
Main features:
- Economic operation low noise operation, minimum power consumption
- Uses normal tap water
- Precipitation free humidification
- No lime deposits on room furnishings and fittings
- No installation required, plug and go
- Fully portable
This unit is suitable for rooms up to 60 m3
 |
|
Specification
|
 |
| Case height |
44mm
|
| Case width |
28mm
|
| Case depth |
30mm
|
| Weight (empty) |
Approximately 4.5kg
|
Case material
|
Pressed steel
|
| Colour |
White/Grey
|
| Power supply |
230 volts 50Hz
|
| Power consumption |
Approximately 25W
|
| Evaporation capacity |
950g/hr. at 25 ºC and 20% RH
|
| Evaporation filter area |
|
Water capacity
|
11 litres
|
| Controls |
Electronic
|
|
|
Hanwell radio contro (if fitted)
|
| Transmitter dimensions |
110 mm x 67 mm x 23 mm |
| Weight |
65 grams |
| Humidity sensor |
Capacitive polymer
|
| Humidity sensor range |
0 to 100% RH (non condensing) |
| Humidity sensor accuracy |
+/- 2% over full range |
| Humidity sensor resolution |
0.1% |
| Switching hysteresis |
Programmable between 1 to 5% |
| Radio frequency |
434.075 MHz |
| Radio power |
10 mW |
| Power supply |
9 volt PP3 battery |
| Battery life |
18 months |
| Sensor transmit rate |
Every 2.5 minutes
|
|
|

|
|